LR的问题，请大家帮忙！！！急急急！！！

lvxm

我用LR的winsock和oracle协议录制，在起动客户端是.cmd文件，录好后能单机运行，运行到当中就会报Error : socket0 - Software caused connection abort. Error code : 10053.

[ Last edited by lvxm on 2005-4-12 at 11:23 ]

lisawater

我也遇到过此类问题,也不是很清楚原因.
但是,从观察的结果来看, 好象是因为lr已经停止了,但是被测端的连接还保持着, 当其发现lr已经停止了时,就报出Software caused connection abort错.

lvxm

不知道错误中的software是指哪个软件？是LR本身？还是被测软件？

xihong2004

路过

super

支持

lvxm

顶，顶，没有人能回答嘛？

lvxm

顶一下！！

lvxm

顶

lvxm

再顶，肯定有高手能解决！

sunshinelius

这是一个winsocket层的标准错误：

Software caused connection abort

  This error message means somewhere the connection was lost and X-Win32 gave up on the connection since it couldn’t re-establish.  This isn’t a problem with X-Win32, but rather somewhere your connection is being lost.  Possible causes are:

-          Windows power savings settings

-          You are going through a router or switch that kills sessions if they are idle too long.

-          Your UNIX host is disconnecting for some reason.

-          There’s too much traffic and not enough bandwidth for X-Win32 to maintain its connection.

   I would suggest:

  

-          Turning off all screen savers and power saving options in Windows, at least until you isolate where the problem is.

-          Trying connections to other hosts to see if it’s a specific switch, hub, or router that’s severing the connections.

-          Try sending something over the connection all the time so it doesn’t quit.  For example, run, “xclock &” once you connect with xterm and see if that helps.

-          Make sure all firewalls are disabled, make sure your UNIX host isn’t under too much stress and the network connections have enough bandwidth to keep connections going.

lvxm

谢谢，版主！