关于usb转串口的WHQL测试

ccy.ybfq · 发表于 2010-10-12 10:02:27

本帖最后由 ccy.ybfq 于 2010-10-12 18:06 编辑

大家好！
我在测试usb转串口的时候测试结果有几个fail的，劳请大家帮忙，详情如下：

=========================================================
Error 10-12-2010 2:34:29.704 下午 Intialization - A device was not found. Please make sure that you have one plugged in.
File: d:\5429t\testsrc\driverstest\usb\compliancetools\usbcheck\usbcommandverifier\source\commonhelperfunctions.cpp Line: 262
Error Type: BOOL
Error Code: 0x0
Error Text: Error 0x00000000

Error 10-12-2010 2:34:29.704 下午 If you are testing a full/low speed device, please connect the device to a USB 2.0 high speed hub and connect the USB 2.0 high speed hub to the USB 2.0 host controller on this system.
File: d:\5429t\testsrc\driverstest\usb\compliancetools\usbcheck\usbcommandverifier\source\commonhelperfunctions.cpp Line: 272
Error Type: BOOL
Error Code: 0x0
Error Text: Error 0x00000000

=========================================================
Error 10-12-2010 2:41:54.626 下午 Device with ID XXXX/XXXX found in tree but tree must be at least 1 external hubs deep but not more than 2 external hubs deep.
File: d:\5429t\testsrc\driverstest\usb\usbhct\exe\selstest.cpp Line: 290
Error Type: BOOL
Error Code: 0x0
Error Text: Error 0x00000000
Result: Fail
Repro: C:\WTT\JobsWorkingDir\Tasks\WTTJobRun2A2C9CA7-2EC7-49DB-B136-E164001A2FFD\usbhct.exe -s -d XXXX/XXXX -l usbhct_s.log

=========================================================
Result: Fail
Repro: UsbVirtTest.exe XXXX XXXX

此问题已解决，但仍有错误在重新测试中，等待。