LoadRunner发生器连接失败

higkoo

用Control连接发生器，可以连接成功。回放时失败，发生器端日志：

DriverLogger: Log started at 02/01/2008 11:53:08 .

02/01/2008 11:53:29 Error: Communication error: Failed to connect to remote host [server name: winxp].        [MsgId: MERR-10343]
02/01/2008 11:53:29 Error: Two Way Communication Error: Function two_way_comm_resolve_userdata failed. Reason: invalid handle.        [MsgId: MERR-60985]
02/01/2008 11:53:29 Error: Communication error: Failed to send message - socket is not connected yet.        [MsgId: MERR-10343]
02/01/2008 11:53:49 Error: Communication error: Failed to connect to remote host [server name: winxp].        [MsgId: MERR-10343]
02/01/2008 11:53:49 Error: Two Way Communication Error: Function two_way_comm_resolve_userdata failed. Reason: invalid handle.        [MsgId: MERR-60985]
02/01/2008 11:53:49 Error: Communication error: Failed to send message - socket is not connected yet.        [MsgId: MERR-10343]
02/01/2008 11:54:09 Error: Communication error: Failed to connect to remote host [server name: winxp].        [MsgId: MERR-10343]
02/01/2008 11:54:09 Error: Two Way Communication Error: Function two_way_comm_resolve_userdata failed. Reason: invalid handle.        [MsgId: MERR-60985]
02/01/2008 11:54:09 Error: Communication error: Failed to send message - socket is not connected yet.        [MsgId: MERR-10343]
02/01/2008 11:54:29 Error: Communication error: Failed to connect to remote host [server name: winxp].        [MsgId: MERR-10343]
02/01/2008 11:54:29 Error: Two Way Communication Error: Function two_way_comm_resolve_userdata failed. Reason: invalid handle.        [MsgId: MERR-60985]
02/01/2008 11:54:29 Error: Communication error: Failed to send message - socket is not connected yet.        [MsgId: MERR-10343]

控制台日志：

Index.c(5): Error -27216: Invalid argument (number 7)
vuser_end.c(8): Error -27792: Failed to transmit data to network: [10054] Connection reset by peer

higkoo

控制台里显示的参数错误  不明白
运行Vgen脚本没有错误，本地运行Control也是全部Pass，使用其它机器的发生器就报错，奇怪。

msnshow

没遇到过,顶一下,看看哪位高手回答一下

kakamissyou

你是不是在VUG里面回放成功？在Control里面使用了IP欺骗之后就包错？如果是这样的话，把
把杀毒软件关了就好了，仅供参考！我碰到和你类似的情况！

现在的杀毒软件很强，看到你一直快速的往外发就把你停了，然后LR返回一个程序错误给你，让我们这些用户看不懂，呵呵！