|
在Linux下,由于bugzilla下载安装缺少模块太麻烦。所以大多数人都选择perl安装,但在perl安装中遇到问题,请高手指点。
[root@test bugzilla]# /usr/bin/perl -MCPAN -e 'install "Image::Magick"'
CPAN: Storable loaded ok
Going to read /root/.cpan/Metadata
Database was generated on Sun, 02 Mar 2008 15:30:49 GMT
Running install for module Image::Magick
Running make for J/JC/JCRISTY/PerlMagick-6.32.tar.gz
CPAN: Digest::MD5 loaded ok
CPAN: Compress::Zlib loaded ok
Checksum for /root/.cpan/sources/authors/id/J/JC/JCRISTY/PerlMagick-6.32.tar.gz ok
Scanning cache /root/.cpan/build for sizes
./PerlMagick-6.32/
./PerlMagick-6.32/.gdbinit
./PerlMagick-6.32/Changelog
./PerlMagick-6.32/demo/
./PerlMagick-6.32/demo/smile.gif
./PerlMagick-6.32/demo/composite.pl
./PerlMagick-6.32/demo/src.png
./PerlMagick-6.32/demo/pink_flower.gif
./PerlMagick-6.32/demo/Makefile
./PerlMagick-6.32/t/subroutines.pl
Removing previously used /root/.cpan/build/PerlMagick-6.32
CPAN.pm: Going to build J/JC/JCRISTY/PerlMagick-6.32.tar.gz
Checking if your kit is complete...
Looks good
Note (probably harmless): No library found for -lgvc
Writing Makefile for Image::Magick
make: *** No rule to make target `1'. Stop.
/usr/bin/make 1 -- NOT OK
Running make test
Can't test without successful make
Running make install
make had returned bad status, install seems impossible
[root@test bugzilla]#
[ 本帖最后由 comecome 于 2008-3-6 11:46 编辑 ] |
|