LR8.1监控linux系统

ljitry02

LR8.1监控linux系统一般需要监控些什么参数和怎么设置？（我是新手请大家多指教）

PrefTest

1、下载rpc.rstatd-4.0.1.tar.gz
2、解压缩
tar -zxvf rpc.rstatd-4.0.1.tar.gz
3、配置
./configure
4、编译
make
5、安装
make install
6、启动
rpc.rstatd
7、在LoadRunner中添加计数器


average load : Average number of processes simultaneously in Ready state during the last minute.(在过去的1分钟，的平均负载)
cpu utilization: Percent of time that the CPU is utilized.(cpu的使用率)
disk traffic: Rate of disk transfers.（磁盘传输率）
paging rate：Number of pages read to physical memory or written to pagefile(s), per second.（每秒从磁盘读到物理内存，或者从物理内存写到页面文件的内存页数）
Swap-in rate: Number of processes being swapped-in to memory, per second.（每秒交换到内存的进程数）
Swap-out rate: Number of processes being swapped-out from memory, per second.（每秒从内存交换出来的进程）