Dim qtApp 'As QuickTest.Application ' Declare the Application object variable
Dim qtTest 'As QuickTest.Test ' Declare a Test object variable
Dim qtResultsOpt 'As QuickTest.RunResultsOptions ' Declare a Run Results Options object variable
Set qtApp = CreateObject("QuickTest.Application") ' Create the Application object
qtApp.Launch ' Start QuickTest
qtApp.Visible = True ' Make the QuickTest application visible
' Set QuickTest run options
qtApp.Options.Run.ImageCaptureForTestResults = "OnError"
qtApp.Open "C:\AutoTest\Model\BP\SC-03-001", True ' Open the test in read-only mode
' set run settings for the test
Set qtTest = qtApp.Test
qtTest.Settings.Run.IterationMode = "rngIterations" ' Run only iterations 2 to 4
qtTest.Settings.Run.StartIteration = 2
qtTest.Settings.Run.EndIteration = 4
qtTest.Settings.Run.OnError = "NextStep" ' Instruct QuickTest to perform next step when error occurs
Set qtResultsOpt = CreateObject("QuickTest.RunResultsOptions") ' Create the Run Results Options object
qtResultsOpt.ResultsLocation = "C:\AutoTest\Model\BP\SC-03-001\Res1" ' Set the results location
qtTest.Run qtResultsOpt ' Run the test
MsgBox qtTest.LastRunResults.Status ' Check the results of the test run
'qtTest.Close ' Close the test
Set qtResultsOpt = Nothing ' Release the Run Results Options object
Set qtTest = Nothing ' Release the Test object
Set qtApp = Nothing ' Release the Application object